Above Ground Pool Wall Came Out Of Track

Reapply boiling water as many times as needed to get the liner back into the track.

Above ground pool wall came out of track. Wall anomalies are usually caused by the pool being out of. This type of repair can easily cause cove damage. A wall out of the track usually happens when the track sinks and becomes too low. If the cove is intact and you did not need to drain your pool all is good.

Pool liners on above ground and in ground pools are held in place by a track. While you are cleaning the track out with a dull screwdriver or a popsicle stick inspect the track for any cracks or missing pieces. We leveled the ground and have the pool tracking and wall in place. The next two photos show damage that should be fixed.

Old pool liner coming out of coping track. The liner only stays warm for a few seconds so you need to work quickly. Clean out the track. On one side i have noticed that the wall keeps popping out of the track and we push it back in and with in a few minutes it will be.

The liner can pop out of the track for various reasons including damage to the track liner shrinkage or water behind. It is 2 years old and we took it down ourselves. When your repairs are made check the cove area on the inside of the pool. We are in the process of putting up an 18ft above ground pool that we bought used.

Hi we have a 15 foot round above ground pool that was installed last year and has staggered bolts where the bolts are the pool is buckling in the installer came back out and made sure everything was in its tracking level and said this is a manufacturer s fault i spoke to the manufacturer they re telling me it s an install problem both are. Check under the top rails and make sure the coping is still covering the liner and the rods are still covering the coping. You may find ants dirt or even dried up mud in the track. This is all important stuff if the liner is coming off the wall that should get fixed.

We were very careful with everything and bought a new liner.